El Cameo - Flipbook - Page 29
Bed Fabrication
end
of the
to lower
the overall
created
fullbed
length
templates
to check consistency the length of the truck as well as side to side.
height for the desired look. Eliminating
that large of an area prompted Dan to
completely re-fabricate the entire length
of both sides. Starting with the bed
sides he used handmade dies in the
shop's Pullmax machine and handformed the panels. Special attention
was given to the rear wheel openings to
make the lines flow better as well as
making them larger accounting for the
larger wheel diameters.