UL Catalog 2022-2023 - Flipbook - Page 46
FIXED LENGTH
SUBMERSIBLE
TURBINE PUMPS
FE PETRO® 2 Hp, 1½ Hp, ¾ Hp, and ⅓ Hp fixed speed
submersible pumps are available with fixed lengths.
SPECIFICATIONS
General
• Check valve: 2¾" diameter fluorocarbon seal constructed on
cast aluminum body and aluminum backing washer.
Power Requirements
• Fixed length, fixed speed models require single-phase,
208-230 VAC, 60 Hz incoming power.
• Pressure relief valve: available in four pressure relief settings,
integral to check valve. Standard model relieves at 40 psi
and resets above 35 psi.
• Fixed length, fixed speed models are available in ⅓, ¾, 1½,
and 2 Hp versions.
• Syphon: venturi-type syphon primer supplied with every
submersible. Syphon check valve and secondary syphon
sold separately.
• Air eliminator: every submersible includes a tank return path
with one-way check valve to provide active air elimination.
• Electrical disconnect: electrical yoke for positive contractor
disconnect during service.
Pump Motor
• Fixed speed, 3450 rpm, multi-stage centrifugal
type pump motor with integral, automatic, thermal
overload protection.
• ⅓ and ¾ Hp fixed speed models are available as
two-stage versions.
• A 370 Volt, 15 microfarad rated capacitor is used with ⅓, ¾,
and 1½ Hp fixed length, fixed speed versions.
• A 370 Volt, 40 microfarad rated capacitor is used with 2Hp
fixed length, fixed speed versions.
• SPGC-220 Guardian Series™ Single Phase Smart Controller
and STP-CBS single-phase control boxes are available for
fixed speed pump control.
Liquid Compatibility
• Max. liquid viscosity: 70 SSU at 60 °F (15 °C).
• Fixed length STP models are UL listed for fuel mixtures
containing up to 10% ethanol with gasoline, and 20%
MTBE, 20% ETBE or 17% TAME with gasoline.
• 1½ and 2 Hp fixed speed models are available in
standard pressure (two-stage) versions and high
pressure (H option, three-stage) versions.
• STPAG/STPAP (AG compatible) models are UL listed for fuel
mixtures containing diesel fuel with up to 20% Biodiesel,
100% Biodiesel, up to 85% ethanol with gasoline, and 20%
MTBE, 20% ETBE or 17% TAME with gasoline.
Approvals
• cULus listed.
• Fixed length models can also be used with diesel fuels,
fuel oils, kerosene, Avgas, and jet fuels in a non-gelled
pourable state.
• Consult factory for applicable approvals.
•
46
• Fixed length, fixed speed models incorporate a starting and
running capacitor with internal bleed resistor.
Franklin Fueling Systems is an ISO 9001
Certified Manufacturer.
• All wetted elastomers are made of a high grade,
fluorocarbon compound.