UL Catalog 2022-2023 - Flipbook - Page 47
ORDERING INFORMATION
Fixed Length Submersible Pump Ordering Guide
A typical turbine model designation has up to five components to
define the pump being supplied as follows:
SUBMERSIBLE
PUMPING SYSTEMS
A typical turbine model designation has up to five components
to define the pump being supplied as follows:
STP XXXXX Y - A - B
STP = Basic Model Designation
XXXXX = Factory Installed Options
STP model designations may include one or more of the
following characters in alphabetical order:
(B)
RISER
LENGTH
AG = Alcohol-gasoline compatible (up to E85, up to B20,
and B100)
Note: Standard models up to 10% ethanol capable.
F = Floating suction adapter (1½" NPT female adapter)
H = High pressure (1½ hp and 2 hp models only)
K = Intake filter screen (IFS, factory installed to PMA)
M = MagShell® (2 Hp models only)
(A)
MODEL
LENGTH
*R = Model R check valve (24 psi relief / 22 psi reset
for PLLD)
*W = Model W check valve (16 psi relief/13 psi reset
for PPM4000)
Y = Pump Motor Horsepower Rating
33 = ⅓ Hp fixed speed
75 = ¾ Hp fixed speed
150 = 1½ Hp fixed speed
200 = 2 Hp fixed speed
A = Model Length
Model length is expressed as three numeric characters that
indicate the length of the STP from the turbine manifold
bottom to the pump motor inlet in inches, available from 37"
to 246" (additional charge for models 133" and longer).
B = Riser Pipe Length
Riser pipe length is expressed as two numeric characters that
indicate the total length of the riser in inches. Riser pipes are
available from 7" to 60" in 1" increments (additional charge
for risers 31" or longer).
*Note: If not otherwise specified, all STP models supplied with standard model check
valve (40 psi relief / 35 psi reset for MLD, TS-LS300, and TS-LS500).
47