STE 2021 Catalog - Flipbook - Page 407
PHONE 800•438•0671
HYDRAULIC PUMPS
Reliable Electric Hydraulic Pump
Reliable Gasoline Hydraulic Pump
Is designed for use with single or double acting 10,000 psi
Is a single/double acting 10,000 psi high pressure pump
by a low pressure pump for rapid tool advance. The 5/8 hp
crimping or cutting tools. The unit has a 6 hp briggs/
high pressure remote tools. The pump features intermittent
duty two stage piston style pumping system, complimented
universal electric motor will operate from any 115 volt AC
power supply. The unit has a 3 quart oil reservoir. Operable
with toggle switch or 8' remote hand control.
REL-1915
Electric Hydraulic Pump,
10,000 psi, 5/8 hp
which features a manual lever operation two stage
pumping system to ensure rapid tool advance for remote
stratton OHV engine. The factory installed SA & DA
couplers are ready to run your single or double acting
crimping or cutting tools. High-pressure safety relief valve
factory filled 2 gallon hydraulic fluid reservoir with sight
glass. Tubular steel frame.
REL-GB-10
Gasoline Hydraulic Pump,
10,000 psi, 6 hp
REL-GB-10
Fax: 704•482•7349
REL-1915
Huskie Electric Hydraulic Pump
Has a 1/2 Hp motor to produce 10,000 psi for use with
high pressure remote hydraulic tools. Remote operated
pump gives the operator complete control. Push buttons
permit the user to advance and retract at will. The user
is never committed to a full cycle, and can always back
off at any time during the advance even under pressure.
This feature increases efficiency because cuts and crimps
can be adjusted as necessary, simply by stopping the
advance or retract mode. A 10-foot remote control cable
provides both safety and convenience. The user can set
up an operation and then move away from the work site
before engaging the tool. An over-ride switch on the pump
allows full control at the pump motor. The low amperage
of this pump allows it to be used virtually anywhere. The
pressure can be easily adjusted between 4,000 and 10,000
psi. Consult factory for proper adjusting procedure. NOTE:
When using any of these high pressure tools, always use
10,000 psi rated non-conductive hose.
HUS-R-14EH
405
HUS-R-14EH
Electric Hydraulic Pump,
10,000 psi, 1/2 hp
Reliable Hydraulic Intensifier
Features a single acting control system which provides a
unique solution to your high pressure single acting tooling
requirements. This system combines the power of a high
pressure intensifier with the simplicity of a fixed position three
way control valve. The intensifier/valve design allows return oil
to bypass the intensifier and return directly to the tank (return)
line, increasing tool speed and performance. The RL-REL-10-ISA provides quick advance and retract for single acting spring
return tools, without the need for additional high pressure
hoses, couplers or an in-line control valve. 1,400-2,000 psi
operating pressure. 4-7 gpm flow range.
REL-10-ISA
Hydraulic Intensifier, 10,000 psi
REL-10-ISA
HYDRAULIC PUMP & INTENSIFIER
POWER EQUIPMENT | HYDRAULIC
404