STE 2021 Catalog - Flipbook - Page 410
PUNCH & POLE PULLER
Tiiger Hydraulic Utility Pole Puller
Reliable 35 Ton Hydraulic Steel Punch
Was designed to punch through 1/2" aluminum, copper, and mild steel. The punched
hole size is 1/16" larger than your bolt size. A stripper guide extends on either side of
the ram to strip the material after punching. This portable hand-held unit will operate
from any 10,000 psi hydraulic pumping source. Applications include punching of bus
bars, tower iron, railing, l-beams, and truck frames. Punch Kit comes complete with
four punch and die sets for 3/8", 1/2", 5/8", and 3/4" bolts, and steel carrying case.
REL-35T-PNC
35 Ton, Punch Kit
Helps prevent personal injury associated with using a boom truck. At only 57 pounds, Tiiger’s
pole puller is the lightest on the market. Reduces boom damage and maintenance cost resulting
from pulling poles. Dramatically increases productivity and cuts time. Lifting capacity @ 50,120
pounds. Swivel fabricated with high yield strength steel in excess of 100,000 psi. Hook assembly
manufactured with all stainless steel components. Base plate has the lowest possible center of
gravity, minimizing tipping and provides wide distribution of force during a pull. Base plate is
engineered with the strength to take the full force of the pole pulling and the flexibility not to
crack under soft ground conditions. Low point of attachment lets you cut the pole closer to the
ground. Back plate prevents chain roll-up and slippage. Swivel assembly pre-tensions the chain
providing maximum lift per stroke. 2800 psi operating pressure.
TII-4001D
Fax: 704•482•7349
REL-35T-PNC
Tiiger, Pole Puller Kit
Huskie 35 Ton Hydraulic C-Frame Punch
The portable SH-370M punch was designed to punch holes through 1/2″ mild steel,
aluminum and copper. The punched hole size is 1/16″ larger than your bolt size. A
stripper guide extends on either side of the ram to strip the material after punching.
This hand-held unit will operate from any 10,000 psi hydraulic pumping source.;
Some uses include the punching of bus bars, tower iron, railing, I-beams and truck
frames. Custom size punch and dies are available upon request. Oval and square
sizes are also available. Consult factory for order information. The SH-370M comes
complete with four sets of punch and die sizes for 3/8″, 1/2″, 5/8″ and 3/4″ bolts
and carrying case
HUS-SH370M
HUS-SH370M
35 Ton, Punch Kit
Tiiger Hydraulic Utility Pole Puller Pad
Pole Puller Pad (29" X 24" X 1.25") is engineered with the strength to take the full
force of the pole pulling, and the flexibility not to crack. The base plate is designed to
provide for the lowest possible center of gravity, swivel and hook assembly allow for
pre-tensioning of the chain and a reduction of stress on the chain.
TII-HA0040
Tiiger, Pole Puller Pad
409
POLE PULLER
PHONE 800•438•0671
POWER EQUIPMENT | HYDRAULIC
408