STE 2021 Catalog - Flipbook - Page 419
Reliable Hydraulic Intensifier
Features a single acting control system which provides a unique solution to your high
pressure single acting tooling requirements. This system combines the power of a high
pressure intensifier with the simplicity of a fixed position three way control valve. The
intensifier/valve design allows return oil to bypass the intensifier and return directly
to the tank (return) line, increasing tool speed and performance. The RL-REL-10-I-SA
provides quick advance and retract for single acting spring return tools, without the
need for additional high pressure hoses, couplers or an in-line control valve. 1,4002,000 psi operating pressure. 4-7 gpm flow range.
REL-10-I-SA
REL-10-ISA
Hydraulic Intensifier, 10,000 psi
419
HYDRAULIC PUMP & INTENSIFIER
POWER EQUIPMENT - HYDRAULIC
Huskie Electric Hydraulic Pump
Has a 1/2 Hp motor to produce 10,000 psi for use with high pressure remote
hydraulic tools. Remote operated pump gives the operator complete control. Push
buttons permit the user to advance and retract at will. The user is never committed
to a full cycle, and can always back off at any time during the advance even under
pressure. This feature increases efficiency because cuts and crimps can be adjusted as
necessary, simply by stopping the advance or retract mode. A 10-foot remote control
cable provides both safety and convenience. The user can set up an operation and
then move away from the work site before engaging the tool. An over-ride switch
on the pump allows full control at the pump motor. The low amperage of this pump
allows it to be used virtually anywhere. The pressure can be easily adjusted between
4,000 and 10,000 psi. Consult factory for proper adjusting procedure. NOTE: When
using any of these high pressure tools, always use 10,000 psi rated non-conductive
hose.
HUS-R-14EH
HUS-R-14EH
Electric Hydraulic Pump, 10,000 psi, 1/2 hp
The REL-GH-10 single/double acting pump features manual lever operation,
continuous duty performance, and a two stage pumping system, to ensure rapid tool
advance. The factory installed couplers are ready to run your single or double acting
crimping or cutting tools. Dims: 24"H x 26"D x 18"W, Wt. 116 lbs.
REL-GHS-10
Gasoline Powered Single And Double Acting Hydraulic Pump
REL-GHS-10
www.safetytest.net
Gasoline Powered Single And Double Acting Hydraulic Pump