Visit Installers guide EN - Flipbook - Sida 6
VISIT TRANSMITTERS
Visit door transmitter
BE1411
Installation – single sound source
Buttons and connections
Test / program buttons
LED lights
3.5 mm ext. mic. input
Internal microphone
BE9199 / BE9200
External microphone
Using the transmitter’s internal microphone
1 Pull the battery tab to start the transmitter.
Clean the wall with the wet wipe and remove the protective film from the Velcro.
2 Mount the door transmitter to the left of the doorbell’s sound source, as close as possible.
You can also use the supplied screw and plug.
1
2
Max 3 cm, 1.2"
Sound source
Doorbell push button
Ext. trig. input
Alternative installation – single sound source
Using the external microphone accessory
Technical specifications
5
In the box
Dimensions and weight
Frequency and coverage
BE1411 Visit door transmitter
21.5 V AA (LR6)
lithium or alkaline batteries
Velcro for wall mounting
Screw and wall plug
Height: 100 mm, 4.0"
Frequency: 315 MHz, 433.92 MHz or
868.3 MHz, depending on region
Power and battery
Activation
Battery power
21.5 V AA lithium or
alkaline type batteries
The test buttons and the int. mic.
Width: 65 mm, 2.6"
The electromagnetic detector
Coverage by region:
315 MHz: Up to 50 m (164 ft)
433 MHz: 30 – 80 m (98 - 260 ft)
868 MHz: 50 – 250 m (55 - 273 yd)
Coverage depends on the radio
frequency, building’s characteristics
and the combination of transmitters
and receivers.
The external microphone accessory
Inputs
Power consumption
Active < 70 mA
Idle position < 15 μA
The existing doorbell connected to
the external trigger input
3.5 mm external microphone input
External trigger input
Environment
Accessories
Operation time
Alkaline batteries:
~ 5 years
Lithium batteries:
~ 10 years
For indoor use only
Operating temperature
0° to 35° C, 32° to 95° F
The following accessories are available:
BE9199 External microphone
2.5 m, 8.2'
BE9200 External microphone
0.75 m, 2.4'
Depth: 27 mm, 1.1"
Weight: 120 g, 4.2 oz. incl. batteries
Relative humidity
15% to 90%, non-condensing
1 Connect the external microphone (sold separately) to the transmitter.
Remove the protective film and attach it to the intercom’s speaker.
2 Pull the battery tab to start the transmitter. Remove the protective film from the Velcro and mount the transmitter on the wall.
3 Within 2 min, press the lower button 10 times to turn off the internal microphone. The LEDs will blink 3 times in red to confirm.
Note: If you exceed 2 minutes, you need to restart the transmitter by removing the batteries and putting them back in again.
1
2
3
10
Ext. mic.
(sold separately)
Turning the internal microphone back on
Restart the transmitter by removing the batteries and putting them back in. Within 2 minutes, press the lower button
10 times to turn the internal microphone back on. The LEDs will blink 3 times in green to confirm.
6