Visit Installers guide EN - Flipbook - Sida 58
VISIT RECEIVERS
Visit wrist receiver
BE8102
Getting started
Buttons and controls
Silicone wrist band
Visit LEDs
Battery LED
3.5 mm bed shaker input
BE1270 bed shaker
1 Pull the battery tab on the charger and connect the power supply to the mains outlet. The mains LED lights up in green.
Place the wrist receiver in the charger and charge it for at least 2 hours. The charging LED is green during charging.
2 To test the radio link you need a Visit transmitter. Press the test button/s on the transmitter.
3 The receiver starts to vibrate and lights up a Visit LED. If a bed shaker is connected during charging, it will vibrate.
If nothing happens, see Troubleshooting.
1
2
3
”click”
Function button
Mains LED
Charger
Bed shaker
test button
Charging LED
Power supply
Default signal pattern
Technical specifications
In the box
Dimensions and weight
BE1560 Visit wrist receiver
BE1570 Charger
Elastic wrist band
Power supply
Height
Receiver
49 mm, 1.9"
Charger
100 mm, 3.9"
Width
38 mm, 1.5"
95 mm, 3.7"
Depth
12 mm, 0.5"
117 mm, 4.6"
Weight 30 g, 1.1 oz.
300 g, 10.6 oz.
For indoor use only
Operating temperature
0° to 35° C, 32° to 95° F
Relative humidity
15% to 90%, non-condensing
Power and battery
Visit LEDS
Frequency and coverage
Mains power: 7.5 V DC/1500 mA
The Visit LEDs normally indicate
the following:
Frequency: 868.3 MHz
Power consumption
Receiver: Active: 100 mA, Idle: 3 mA
Charger: Active: 650 mA, Idle: 70 mA
Orange LED, pacifier symbol
The baby monitor is activated
Battery power
Receiver: 11.2 V V40H rechargeable
Charger: 41.2 V NiMH rechargeable
Yellow LED, telephone symbol
The phone transmitter is activated
Operating and charging time
Receiver: ~30 h, Charging time: ~10 h
Charger: Battery charging time: ~24 h
57
Environment
Green LED, door symbol
The door transmitter is activated
Red LED, fire symbol
The smoke alarm is activated
Orange and red LEDs blink alternately
The CO alarm is activated
Coverage:
50 – 250 m (55 - 273 yd)
Coverage depends on the
radio frequency, building’s
characteristics and the
combination of transmitters
and receivers.
When a transmitter is activated, the wrist receiver lights up an LED and starts to vibrate with a certain pace. This is called
signal pattern. The transmitters determine the pattern, and the default is as follows:
Activated transmitter
Door transmitter
Push button transmitter
Telephone transmitter
Baby monitor
Smoke alarm
CO alarm
Wrist receiver LED
Wrist receiver / bed shaker vibration
Green
Green
Yellow
Orange
Red
Orange and red
Slow
Slow
Medium
Fast
Long
Long
Changing the signal pattern
The signal pattern can only be changed on the transmitters. See Changing the signal pattern for the relevant transmitter.
LED indications
When the wrist receiver battery is nearly depleted, the battery LED starts to blink in yellow. The charging time is up to 8 h.
The charger is equipped with a battery backup and the charger LEDs indicate the following:
LED
Indication
Status
Charging LED
Green light
The receiver battery is being charged.
Accessories
Mains LED
Green light
The charger is powered by mains voltage.
BE1270 Bed shaker
Mains LED
Green blinks
The charger is powered by the battery backup.
58