Visit Installers guide EN - Flipbook - Sida 67
VISIT ACCESSORIES
Pager charger
BE1260
Getting started
Buttons and controls
Charger brackets
BE1270 bed shaker
1 Important! Replace the old alkaline battery with the supplied 1.2 V NiMH rechargeable battery.
2 Fit the supporting legs to the back of the charger and place it on a level surface. You can also mount it on the wall using
the supplied screws and plugs.
3 Connect the power supply to the mains outlet and place the pager in the charger. The charging LED is green during
charging and goes out when the pager is fully charged. Connect the bed shaker and tuck it under the pillow or mattress.
2
1
Charging pins
Charging LED
2bed shaker jacks
Supporting legs
In the box
Power and battery
Dimensions and weight
BE1260 Pager charger with
pre-mounted backup batteries
Mains power: 8 VDC / 800 mA
Height: 78 mm, 3.1"
Battery power
41.2 V NiMH rechargeable batteries
Width: 88 mm, 3.5"
11.2 V NiMH rechargeable battery
intended for the pager
Supporting legs and screws + plugs
Charging LED
Green light: The pager is charging
No light: The pager is fully
charged or the power supply is not
connected to mains power.
Testing the connection
Note: Charge the backup batteries for 24 hours before using it with a bed shaker.
Technical specifications
External power supply
Note: The backup batteries must be
changed at a service centre.
Pager charging time
Normal charging time:
~6h
With depleted backup batteries:
~ 24 h
Vibrator power: 2.0 – 4.0 VDC
Depth: 43 mm, 1.7"
Weight: 200 g, 7 oz. incl. batteries
and power adapter
1 To test the radio link you need the pager and a Visit transmitter. Press the test button/s on the transmitter (see Testing
the connection for the relevant transmitter).
2 If the pager is placed in the charger, it lights up a Visit LED and the bed shaker starts to vibrate.
If nothing happens, see Troubleshooting.
Troubleshooting
Most problems with the charger can be solved quickly by following the advice below.
Environment
If
Try this
For indoor use only
The pager doesn’t charge when it’s
placed in the charger
Check that the pager is positioned correctly in the charger. The charging LED
will light up in green to show that the pager is being charged.
Accessories
If the charging LED doesn’t light up, the backup batteries may be depleted.
Connect the power supply to mains power and charge the backup batteries.
BE1270 Bed shaker
Connects up to two bed shakers
The bed shaker doesn’t vibrate when
the the pager is activated
Warning! When using the pager charger ONLY USE RECHARGEABLE NiMH BATTERIES in the pager.
Non-rechargeable batteries will start to leak if the pager is placed in the charger and the battery acid will
damage the electronics. The resulting damage is not covered by warranty.
65
3
Check that the bed shaker is connected correctly to the charger.
Check that the pager is positioned correctly in the charger. The charging LED
will light up in green to show that the pager is being charged.
If the charging LED doesn’t light up, the backup batteries may be depleted.
Connect the power supply to mains power and charge the backup batteries.
66