Visit Installers guide EN - Flipbook - Sida 69
Mobile phone sensor
Mobile phone sensor
BE9250
Note: Not available on all markets.
Using BE9250 with the alarm clock
Buttons and connections
Ergonomic grip
2.5 mm connector
3.5 mm connector
1 Open the battery compartment, fit the supplied battery and connect the mobile phone sensor to the 2.5 mm input.
2 Connect the adapter to the 3.5 mm ext. trig. input on the back of the alarm clock.
3 Place the sensor on the mobile phone or tablet display and use e.g. a landline telephone to call the mobile phone.
When the display lights up, the yellow Visit LED on the alarm clock blinks and it starts to sound, flash and vibrate.
1
2
3
Using BE9250 with the flash receiver
1 Connect the mobile phone sensor to the 2.5 mm ext. trig. input on the back of the receiver.
Place it on the mobile phone or tablet display.
2 Use for instance the landline telephone to call the mobile phone. When the mobile phone display lights up, the yellow
Visit LED on the receiver lights up and it starts to flash.
Low centre of gravity
Anti-slip surface
Battery compartment
1
Technical specifications
Technical specifications
The model has an adapter and connects to all Bellman &
Symfon products with a 2.5mm or 3.5 mm interface.
Battery power: 1AAA 1.5 V alkaline battery
Compatibility
Light sensitivity: Visible light >3 lux for longer than 2 s
BE1431 Visit telephone transmitter
BE1491 Visit baby monitor
Connectors:
Mobile phone sensor: 2.5 mm mono jack plug
Adapter: 3.5 mm mono jack plug
BE1510 Visit Repeater
Cable length: 120 cm, 4'
2 Use for instance the landline telephone to call the mobile phone. When the mobile phone display lights up,
the transmitter top LED lights up in green to show that a radio signal is being transmitted.
BE1580 Visit alarm clock
Sensor dimensions and weight: 243424 mm, 20 g
Adapter dimensions and weight: 532518 mm, 27 g
3 The yellow Visit LED on the receiver lights up to show that the signal was received.
In addition, it starts to sound, flash or vibrate depending on the receiver.
BE1441 / BE1442 Visit flash receiver
BE1370 Alarm clock pro
Optical detection: Activated when the display lights up
Using BE9250 with the telephone transmitter
1 Open the telephone transmitter front cover and connect the mobile phone sensor to the 2.5 mm ext. trig. input.
Place it on the mobile phone or tablet display.
1
67
2
2
3
68