2022-Ultrafeed LSZ Guidebook - Flipbook - Page 12
Presser Feet & Feed Dog Installation
11
10
A
B
How to Install Center & Outside Feet
1. With the foot raised, rotate the balance wheel
so that the outside foot is at its highest position.
Loosen the screw enough to slip off the foot
(A); screw does not need to be removed.
2. Rotate the balance wheel so the needle is
at its highest position and then remove the
center foot (B). Screw must be removed.
NOTE: If installing a feed dog, jump to “How to
Install a Feed Dog” before proceeding to step 3.
3. With the needle at its highest position, install
the center foot (B) and tighten its screw.
4. To install the outside foot, rotate the balance
wheel so the outside foot bracket is at its highest
position. Slide the outside foot underneath the
screw and push it up so it rests firmly against the
bracket and loosely tighten the screw (A).
5. Lower the foot and rotate the balance
wheel until the needle is in its highest
position. Firmly tighten the screw (A).
Scan to watch a video on how
to install a presser foot set.
9 |
Sailrite.com