2022-Ultrafeed LSZ Guidebook - Flipbook - Page 22
Picking Up Bobbin Thread
1. With the needle threaded and the thread passed through the center foot, hold the needle thread loosely to the right (24).
Grab the top of the balance wheel and rotate toward the front of the machine (29) until the needle moves down and then
back up.
2. As the needle nears its highest point, pull the needle thread gently. The bobbin thread should come up through the needle
hole, with the needle thread, in the form of a loop (25).
3. Pass a small instrument (pen, seam ripper, screwdriver, etc.) under the presser foot from right to left to pull the thread out
away from the machine (26 and 27).
NOTE: If the bobbin thread does not appear when the needle is lowered and raised, check to make sure 5 to 6 inches of
bobbin thread is hanging loosely from the bobbin case and repeat steps 1-3 again.
24
25
26
27
19 |
Sailrite.com