2022-Ultrafeed LSZ Guidebook - Flipbook - Page 51
69
J
I
H
K
Adjust the Driver
The driver (C) is secured to the lower shaft with two set screws (H). Loosen the screws and gently twist the shuttle driver
to match (G). If the fit to the shaft is tight, carefully use a screwdriver as leverage. Do not allow the driver to move to the
left, which would be evident by any play between J and K. Once proper position is found, retighten the two set screws
(H).
Grab the lower shaft (I) and move it left and right. There should be no movement between J and K. If there is movement
between J and K then the driver (C) has shifted left on the lower shaft (I) and must be reset.
After adjusting the driver, check the left-right positioning of the shuttle gib hook (p. 49).
UltrafeedĀ® LSZ Guidebook
| 48