Fabricator Guidebook - Flipbook - Page 16
How to Wind a Bobbin
11
1. Push the bobbin on the bobbin winder
spindle as far as it will go (10).
B
IMPORTANT: If the bobbin spins on the
shaft, remove the bobbin and use a flathead
screwdriver to widen the prongs (A). The bobbin
should fit snuggly.
2. Pass the thread from the thread stand to
the back end of the bobbin winder. Pull the
thread through the hole near the thread
tensioner (B) and then behind and under,
pulling the thread between the disks of the
tensioner (11).
12
3. Bring the thread forward to the bobbin and
push the thread tail through one of the holes
in the bobbin from the inside. Pull the tail out
about 8 inches (12).
10
A
13 |
Sailrite.com