Fabricator Guidebook - Flipbook - Page 17
4. To wind bobbins without running the
machine, pull the Posi-Pin (C) out of the
balance wheel (D) and place it in the PosiPin Nut (E) as shown (13).
13
D
E
NOTE: To wind bobbins while sewing, ignore
step 4.
5. Push the bobbin winder lever (F) forward to
move the wheel against the drive
belt of the sewing machine (14).
C
6. Hold the thread tail (G) and power
the machine to start winding the
bobbin. Cut the tail flush with the
edge of the bobbin after about 20
rotations (15) and then continue
under power until the bobbin is full. If
adjustments are necessary, see “Bobbin
Thread Winding Adjustment” on p. 15.
14
7. To re-engage the machine:
•Push the Posi-Pin (C) gently into the hole
in the face of the balance wheel (D).
•Rotate the balance wheel while lightly
pushing on the Posi-Pin until you feel it
connect with any of the 4 bushing holes.
F
G
15
•Push it all the way in and release.
Sailrite® Fabricator® Guidebook
| 14