Leatherwork Guidebook - Flipbook - Page 41
Bobbin Winding Issues
The bobbin is not filling evenly, either
too much thread on the top or bottom
Locate the bobbin tensioner (D) and loosen the
screw (E) just under the tensioner on the front
of the machine. Move the tensioner down if the
bobbin is filling with too much thread on the
top. Move the tensioner up if there is too much
thread on the bottom. Tighten the screw after
correct positioning.
The bobbin winder stops before the
bobbin is full or after the bobbin has
too much thread
1. There is a bobbin stop (F) right next to the
bobbin winder. Simply loosen the screw
found on top of the black lobe and turn the
stop to change the thread fill level.
The closer the lobe is to the bobbin the
less it will fill, the further away the more it
will fill.
45
F
D
E
Leatherwork® Guidebook
| 38